6 Installation/ Choice of model If you have an unswitched electrical outlet in the ceiling which is not connected via an on/ off light switch, you can fit any model with a built-in pull-cord switch, with or without a lamp. To operate, simply pull the cord to turn the lamp or motor on or off (1). The pull-cord switch also operates the speed control. Alternatively, you can use one of our remote controls to control the speed and the light (5, 6). If you have an electrical outlet in the ceiling controlled by an on/off light switch, you may also use any model with a built-in pull-cord switch (1). Set the required speed using the pull-cord switch. The direction of rotation is set by a slide switch on the fan. The fan now runs at the speed and direction set by the pull-cord switch when the light switch is operated. What electrical connection do you need? To change the speed, use the pull-cord switch. If you want to replace your old ceiling light by a fan with a light, this is easily done. If a simple light switch was used, you can then use this again. The fan‘s pull-cord switch is turned OFF, and the light pull-cord is turned ON. Now as you enter the room you can turn the light on and off just as you used to. If necessary, turn on the fan using the pullcord (1). Furthermore, the light switch can be changed to a SCNR5 5-speed or a 4-speed ST4/150 II controller (2). If you have a two-pole switch (L1, L2, N, E), the motor and the light can be switched on an off independently. For this, use a SCNRL 5-speed controller or an ST4-400 with a built-in light switch (3). The connection of a dimmer for the lamp is possible using a separate phase, in combination with one of our speed controllers. If you are unsure which control you should use in your application, you should contact your electrician. He will advise you professionally. He will also tell you about the various ways in which our fans can be installed. Note, you can buy CasaFan products only at good specialist trade outlets and not at cheap markets. Your dealer will be able to supply you promptly with your chosen product. (1) Fan with/without light Direct connection with no separate wall switch. Separate switching for the fan and the light on successive pulls. (2) Fan with light Direct connection with two wall switches. Separate switching for the fan and the light using the corresponding switches. (3) Fan with light Direct connection using CasaFan SCNRL5 or ST4-150/400 switch. Separate switching for the fan and the light. (4) Fan without light Speed switching at the wall using CasaFan ST4-150II or SCNR5 wall switch / transformer. (5) Fan without light Speed switching using CasaFan FB-FNK or FB-IR remote controls. (6) Fan with light Speed switching and light switching using CasaFan FB-FNK or FB-IR remote controls.
RkJQdWJsaXNoZXIy NjQyNzA=